Long Shower Curtain
A long shower curtain is anything cut past the ordinary seventy-two inch drop, and this page holds three of them: seventy-nine inches, eighty-seven, and ninety-four. The shortest of the three is the one most people actually need, because it clears a high-mounted rod without pooling. The other two exist for ceiling tracks and sloped attic bathrooms, where seventy-nine still leaves a gap.
Reading your rod height before the labels
Run a tape from the top of the rod to where you want the bottom edge to stop, then add three inches for the ring and header. Under about eighty-two, take the seventy-nine inch cut. Between eighty-two and eighty-eight, the eighty-seven. Above that, the ninety-four. The bands overlap slightly on purpose: the last call is whether you want the hem to hover clear of the tile or brush it. Our size chart sets all three against common rod heights.
Where a long shower curtain actually pays off
Less often than the internet suggests, and more decisively when it does. A tub-shower with a rod at ordinary height gains nothing from surplus fabric: the excess lands outside the tub wall and drips there. The payoff comes when the mount is high for a structural reason, tile carried to the ceiling, an overhead track, a slope in a loft bathroom. If your measurement sits at the shallow end, the 84-inch panels are a tighter selection; at the far end the 96-inch range takes over.
Weight is the quiet benefit
A taller cut of the same polyester carries more fabric below the spray line, and that mass is what stops a panel wrapping around your ankles halfway through a shower. The seventy-nine inch group runs heavily to woven textures, waffle weaves and linen-look grounds in muted colour, which hang straighter and crease less than a printed panel. Alongside them sit the clear vinyl panel, a beige waffle weave, the kraken print, and solid navy for depth instead of pattern.
Choosing a longer drop
What counts as long?
Anything past the ordinary seventy-two inch drop. Three cuts above it are stocked here: seventy-nine inches, eighty-seven and ninety-four. Everything shorter belongs to the standard aisles.
Which of the three drops is the safe default?
Seventy-nine inches. It adds seven inches over standard, enough to cover a rod hung above the tile line, without leaving a hem on the floor. Reach for the deeper cuts only when a measurement tells you to.
Is a long shower curtain harder to keep clean?
Only when the hem touches down. A drop finishing clear of the tile stays as clean as a short one and washes the same way. A hem resting on a wet floor is where the trouble begins.
Can extra drop work over a standard tub?
It can, but it rarely helps. The surplus falls outside the tub wall and drips there instead of draining back in. Depth pays off when the rod is high for a structural reason.
Why do the lengths land on odd numbers?
Because these panels are cut to metric sizes and converted. Seventy-nine is two metres, eighty-seven is two hundred and twenty centimetres. Makers round up in their marketing, which is why you will see the same curtain sold as eighty inches elsewhere.
Does more drop help on a curved rod?
Not directly, since a curved rail adds width rather than height. It does change where the hem falls relative to the tub, because the arc pushes fabric outward at the middle. Check the bottom edge still lands inside the rim along the whole curve.